Precautions
Can spindle motor work without inverter?
No, the high-speed spindle motor must be equipped with a frequency converter to use, because our motorized spindle rating the frequency is 400HZ, and the rated frequency of household or three-phase voltage output can only reach 50-60HZ. if the voltage you put in at 50HZ is 220V or 380V, and the motor burns out directly.
Spindle motor proper use steps after the installation is complete, the boot starts at a low speed of 6000 and increases by 3000 every 10 minutes until 24000 after the transfer, it can be used normally. New spindle inside bearings need to be preheated run-in, remember oh! In addition extend the service life of the spindle, when the spindle is normally used, it is best to start the test run for 10-15 minutes.

Large torque long service life Engraving machine no burrs

Extended rotor
High rotation accuracy High spindle accuracy
The assembly is strictly calibrated

Four bearing 4 P4 grade precision bearings, high runout accuracy, high speed rotation during high-speed operation of the main shaft, long service life.


Purchasing instructions
All the spindle motors in our store must be used together with the frequency converter.
All spindle motors in our shop must be used together with frequency converters. Must be by frequency conversion
The machine output voltage because our spindle motor rated frequency is 400HZ, while our household two
The rated frequency of the phase-electric and three-phase voltage output is only 50-60HZ, such as that corresponding to the spindle motor
400HZ, the voltage is 200V, 200HZ corresponds to the voltage is 100V, then 50HZ corresponds to the electricity
The voltage is 27.5V voltage, if you pass 200V or 380V at 50HZ, the spindle motor will
Just burn it, remember!
Hot Tags: 3.2kw water cooled spindle, China 3.2kw water cooled spindle manufacturers, suppliers, cnc mediterranean parts, Er20 Tool Holder, cnc extraordinary parts, cnc new zealand parts, cnc southeast parts, cnc serviceable parts













